개요
햄스터 로봇을 움직이기 위해서는 특별한 소프트웨어가 필요합니다.
햄스터 로봇을 PC에 연결하고 전원을 켜기 전에
소프트웨어를 먼저 설치해야 합니다.
윈도우용 로봇 코딩 소프트웨어 설치
-
Enter the address below into the address bar of your web browser.
http://hamster.school
- Select the
Download
menu and download the installation file for the OS of your PC.
-
Without plugging the USB dongle into the USB port of the PC,
double-click the downloaded installation file to install it.
-
The Robot Coding Software is installed in the following folder. You can move it to another drive or another folder after installation.
C:\RobotCoding
-
When the Robot Coding Software is installed, the device driver of the USB dongle is also installed.
If you have already installed the device driver, press the No or Cancel button not to reinstall the device driver.
맥용 로봇 코딩 소프트웨어 설치
-
Enter the address below into the address bar of your web browser.
http://hamster.school
- Select the
Download
menu and download the installation file for the OS of your PC.
-
Without plugging the USB dongle into the USB port of the PC,
double-click the downloaded DMG file to open the disk image file.
-
Double-click the Silicon Labs VCP Driver.pkg file to install the device driver first.
If you have already installed the device driver, you do not need to reinstall it.
-
Click the RobotCoding-mac64-v2.0.7.pkg file with two fingers to open the pop-up menu,
then select Open With > Installer menu.
-
Click the Open button.
-
The Robot Coding Software is installed in the following folder.
/Applications/RobotCoding.app
리눅스용 로봇 코딩 소프트웨어 설치
-
Enter the address below into the address bar of your web browser.
http://hamster.school
- Select the
Download
menu and download the installation file for the OS of your PC.
- Open a terminal and navigate to the folder where you downloaded the tar.gz file.
- Unzip the tar.gz file by typing the following command in the terminal.
Linux 32-bit:
tar xvfzp RobotCoding-linux32-v2.0.7.tar.gz
Linux 64-bit:
tar xvfzp RobotCoding-linux64-v2.0.7.tar.gz
- Make sure the RobotCoding folder is created.
-
Install the device driver.
If you have already installed the device driver, you do not need to reinstall it.
(1) Open a terminal and log in as root.
(2) Navigate to the drivers folder inside the RobotCoding folder.
(3) Without plugging the USB dongle into the USB port of the PC,
run the shell script by typing the following command in the terminal.
./setup.sh
If the device driver is installed with the USB dongle plugged into the PC, Linux OS does not recognize the USB dongle.
In this case, simply unplug the USB dongle and plug it back in.
목차
Copyright Robot Software Education Institute. All rights reserved.
Please contact prof. Kwang-Hyun Park (
akaii@kw.ac.kr) if you have any problem.
